Looking good? So the big hole in the middle cupboard will have the engine control board. Below will be the smartgauge flanked by the water and fuel tank gauges. In the side of that protruberance we are planning on fitting the bilge pump control panel and above it the horn and tunnel light switches both of these panels will be stainless steel so should complement each other. You can now see the extra width panel in the left hand side cupboard which will have the control lever on the lower part but as this will stick up above the shelf there is a corresponding panel there too. The 12v fuse panel behind the door in the top left cupboard and the 24v below. There will be a shelf between the two. Victron in the bottom middle.
I am getting quite excited about this as it is starting to look like a proper boat.
No comments:
Post a Comment